That leads me to suspect that there's some problem with the way that I have my libraries set up, but as far as I can tell (from scrolling through the project configuration menus) my setup is identical to hers. They all seem to be "wrong" by some angle of rotation.įurthermore, my colleague can open the exact same project out of SVN and do the same procedure, and have no problems. When I come back and do the same update procedure again, I get N footprints that are wrong.
If I press the button and execute the change, everything seems to work. Enable the Show column of the parameters you want to include in the output. Some further information: If I edit some of the footprints in the library and execute the same procedure, I get N + M footprints that need to be updated on the PCB. All Columns - a list of parameters from which you can choose to be included in the output file. Is it possible for a PCB to point to a different set of libraries than the schematic? As far as I can tell, you can't set the libraries when editing a PCB, so that leads me to believe that it's inherited from the schematic. We're pretty religious about syncing/updating, so I think everything should be the same. It transports both power and data over the same two-wire unshielded cable.
This low-level field bus AS i (Actuator Sensor Interface) was designed for easy, safe, and cost-effective interconnection of sensors, actuators, and switches. I'm not quite sure what you mean - we use a shared integrated library that is synchronized via SVN. The ASI4U is a next-generation CMOS integrated circuit for AS-i networks.
0 kommentar(er)
